Tesla Coil Slayer exciter is an easy step by step DIY project to understand the phenomenon of mutual induction and wireless electricity transfer.
Tesla coil
In this post you will learn how to make power full slayer exciter which is also called solid state Tesla coil. The circuit for the Slayer exciter is extremely simple .
Tesla Coil Slayer Exciter
Components
The components required to make a simple Tesla coil are as following:
Power transistor TTC5200 or MJE3055
Resistor 10 kilo ohms
Ceramic Capacitor (any)
Large heat sink
Copper Wire 28 to 30 gauge
PVC Pipe 1 inch in diameter and 1 ft in length
PVC Pipe 1.1/4 inch in diameter and 2 inch in length.
Connecting wires
Power supply 24 to 36 volt
connecting wires
Steps of Construction
Take the PVC pipe of Inch diameter and 1 ft. length and wound the copper wire around it.
Make about 500 turns in such a manner that the wire must not overlap each other and there must not be any gap in between.
It is termed as "Primary coil".
Now take PVC Pipe 1.1/4 inch in diameter and 2 inch in length and turn the wire about 5,6 times, this will be "Secondary Coil".
Make the circuit according to the given circuit diagram.
Circuit Diagram.
Tesla coil circuit diagram
Tesla Coil Slayer Exciter circuit diagram with components
Teacher, Innovator, Love to create, explore new ways to view & imagine things and then make them real
View Comments
Sir why u called coil with more loops as primary while the one with less loops as secondary
Sir i used copper winding enameled wire for coil and its not working , is that necessary to remove enamel from outer surface of coil for this experiment ? or i use wire without enameled in coil . second i used voltage source adapter of 36V and 3Amp. will it be enough for this project ?
i want to make this project with your help guys plz contact me or give me any num of yours plzzzzz
View Comments
Sir why u called coil with more loops as primary while the one with less loops as secondary
Sir i used copper winding enameled wire for coil and its not working , is that necessary to remove enamel from outer surface of coil for this experiment ? or i use wire without enameled in coil . second i used voltage source adapter of 36V and 3Amp. will it be enough for this project ?
i want to make this project with your help guys plz contact me or give me any num of yours plzzzzz